Any machine after a long time of use, more or less there will be some problems, cold regeneration machine is no exception, but these problems will not immediately show up, need operators to find out in time.

冷再生機操作人員在工作中應注意觀察各設備的運行狀況，做好巡查工作，尤其要注意設備的傳動部位是否潤滑良好，有無磨損。此外，還應當仔細查看各連接處是否出現了松動的問題，動物是否靈活等，如果發現了問題的話，應及時進行緊固、修復或者是更換。

The operator of the cold regenerator should pay attention to observe the operation condition of the equipment, do a good job of inspection, especially pay attention to whether the transmission part of the equipment is well lubricated and whether there is wear. In addition, it is necessary to carefully check whether the joints are loose and whether the animals are flexible. If any problem is found, it should be fastened, repaired or replaced in time.

冷再生機出租

Rental of cold recycling machine

在冷再生設備運行過程中，應當注意結合眼睛、耳朵去搞清楚每一種不同的聲音，如果有不正常聲響的話，應查明原因，妥善處理。

During the operation of cold regeneration equipment, we should pay attention to the combination of eyes and ears to find out each different sound. If there is abnormal sound, we should find out the reason and deal with it properly.

此外，還應當善于辨別各種不同的氣味。比如油溫過高，出料溫度超限，電路、電器過載而嚴重發熱，或者是短接燒壞，以及不正常摩擦而造成的過熱等，這些情況都會發出不同的氣味，這時候我們就可以及時發現問題，解決問題。

In addition, we should also be good at distinguishing different odors. For example, the oil temperature is too high, the discharge temperature exceeds the limit, the circuit and electrical appliances are overloaded and seriously heated, or the short-circuit is burnt out, and the overheating is caused by abnormal friction, etc. these situations will emit different smell, at this time, we can find and solve the problem in time.